The difference of S100，S200 and S300

S300 MODEL:
✔️1.OUTPUT PRESSURE
✔️2.AIR+SMOKE MODE
✔️3.FLOW METER/FLOW DIAL
✔️4.PRESSURE GAUGE
✔️5.ADDITIONAL CAP PLUGS KIT

Ancel S300 supports multi-system testing, especially EVAP system

EVAP System Test
Intake System Test
Exhaust Systems Test
Crankcase system test
Car Sealing Test
Fuel Tank System Test
Turbo System Test
Various Pipe Fittings Test

Wide Range of Applications

Free to choose Air/Smoke method to find leaks

Overheat & Anti-frost Protection

▶Overheat Protection
When the temperature of the device exceeds 75℃, power protection will be intelligently activated to turn it off.
▶Anti-frost Protection
The device can also work normally at -20℃.

Built-in with air pump

2 kinds of modes: AIR model+Smoke mode

▶Air mode :First, use the air mode to directly measure the leak, and judge whether there is a leak by the pressure gauge value. If it is less than 0.5bar, it will inevitably leak. If it reaches 0.8bar and above, the pipeline tightness is very good.Then there is no need to waste baby oil
▶SMOKE MODE:After the air mode determines that there is a leak, use the smoke mode to find the leak.

ADDITIONAL CAP PLUGS KIT

How to judge leakage- through the pressure gauge?

▶NO Leak: When the value of the pressure gauge remains unchanged and the flow meter will read zero (ball at bottom of scale), it means that there is no leakage in the system.

▶Small Leak: When the value of the pressure gauge drops and the ball in the flow meter slowly fall to the bottom of the scale, it indicates a small leak in the system.

▶Massive Leak: When the value of the pressure gauge reaches zero and the flow meter ball never falls to the bottom of the scale, it indicates a large leak in the system.

Adjustable Smoke Output Help To Pinpoint Leaks Quick

How to use ancel s300 smoke leak detector?

Step1: Fill in 10ml-20ml test oil (baby oil) to the detector
Step2: Disconnect the pipe that needs to be connect with the detector
Step3: Connect detector with DC12V battery,device starts to work
Step4: The pipe will be filled with smoke,check the leak points

Note:

1. When you use this Ancel 300 Car Smoke Leak Detector for the first time, fill with 10-20ml baby oil. Please be careful NOT to beyond this range.

2. Fresh oil can be filled with only when the smoke gets thin, and it can't be filled over 20ml each time.

3 . Before filling fresh oil, please pour out the left oil in the detector & replace the detector oil regularly.

4. During the process of leak detection, please keep away from smoke-sensitive parts.

5. Do NOT run the detector over 8 minutes continuously. It needs interval rest.

6. The detector has an intelligent protector, if it exceeds the working limit, such as over 75 ℃, it will automatically turn off the power. In this case, please operate it later.

7. The round part of this detector has temperature, please be careful to avoid burns.

8. If the test pipe needs to be disconnected in the middle, please secure the other side with a rubber stopple.

Specification

Power source:12V Fully Charged vehicle battery
Current:6A
Flow rate: <6 L/min
Pressure output:0.8-1.0 bar (0.8-14.5psi)